<ins id="pvjdx"><th id="pvjdx"></th></ins>

        
        

              <address id="pvjdx"><nobr id="pvjdx"><meter id="pvjdx"></meter></nobr></address>

              <form id="pvjdx"></form>

              <address id="pvjdx"><nobr id="pvjdx"><nobr id="pvjdx"></nobr></nobr></address><form id="pvjdx"><form id="pvjdx"><nobr id="pvjdx"></nobr></form></form>

                  <form id="pvjdx"><nobr id="pvjdx"></nobr></form>

                    Products 磁保持繼電器 DS907G 120A

                    產品特性:

                    120A觸點分斷能力 三相磁保持繼電器 符合RoHS 符合IEC62055-31UC3標準

                    適用范圍:

                    適用于預付費電表及集中抄表系統,復合開關,無功補償裝置及其它自動化控制。

                    文件下載:

                    點擊下載

                    基本特性 Speciality:

                    線圈脈沖設置寬度Coil pulse width

                    50msec. Min

                    動作時間Operation time

                    30msec. Max

                    復歸時間Comeback time

                    30msec. Max

                    介質耐壓Dielectric strength

                    觸點與線圈間:

                    Between coil& contact

                    4000VAC

                    (50/60Hz) for 1 min

                    斷開觸點間:

                    Between contacts

                    2000VAC

                    (50/60Hz) for 1 min

                    絕緣電阻Insulation resistance

                    Min.1000M? (500VDC)

                    環境溫度 Ambient temp

                    -40℃~+70℃

                    重量 Weight

                    280g

                    引出端方式 Quick connect

                    PCB&QC

                    封裝形式  Plastic sealed dusted proof

                    塑封、防塵

                    外形尺寸不含輸出端子Size(mm)

                    Output terminal (mm) not included in profile size

                    110 x 52 x 24


                    觸點特性 Contact specification

                    觸點形式 Contact form

                    3A  3B

                    觸點材料Contact material

                    AgSnO2,

                    接觸電阻Contact resistance 

                    0.6mΩ Max.(12VDC 1A)

                    額定負載Contact current(Cosφ=1)

                    120A  250VAC

                    最大斷開電壓MAX disconnection voltage

                    440VAC / 110VDC

                    最大斷開功率MAX disconnection power

                    30000VA

                    額定負載電氣壽命(阻性)Electrical life

                    5×103cycles

                    額定負載電氣壽命(性)Electrical life

                    5×103cycles

                    機械壽命Mechanical life

                    1×105cycles




                    線圈參數
                    Coil specification:        

                    額定電壓(VDC)

                    Rated Voltage

                    吸合、釋放電壓(VDC) 

                    Suction and Release Voltage

                    脈沖寬(ms)

                    Pulse Width

                    線圈電阻(Ω)±10%

                    Coil Resistance(_)+10%

                    6V

                    ≤4.2

                    ≥50ms

                    雙線圈

                    TwinCoil

                    2ΩX7.5

                    9V

                    ≤6.3

                    2ΩX17

                    12V

                    ≤8.4

                    2ΩX28.5

                    6V

                    ≤4.2

                     

                    ≥50ms

                    單線圈

                    Unicoil

                    15Ω

                    9V

                    ≤6.3

                    34Ω

                    12V

                    ≤8.4

                    57Ω

                     

                     

                    尺寸簡圖 安裝尺寸 Installation Sizemm

                    圖片1.png

                    接線圖 Connection Diagram

                     圖片2.png

                    注意事項 Application Notes

                     

                    1. 所有繼電器在出廠時都設為閉合狀態。在裝運或組裝的過程中繼電器可能會變成釋放的狀態。因而使用時(電源接入時)請根據需要重新將其設置為復歸狀態。

                    2. 為了使繼電器保持在吸合或釋放的狀態,線圈電壓需達到額定電壓,為確保磁保持繼電器動作或復歸脈沖寬度小于50ms。不要向線圈上的Pin1和Pin2施加電壓超過一分鐘以上,以防線圈損壞。

                    3. 繼電器有極性區分,用戶需指明屬于何種極性。

                    4. 繼電器入廠檢驗及使用輕拿輕放,防止損壞影響參數,入廠做破壞性檢查的產品要與正常產品嚴格區分標識,不得裝機使用。

                    5. 非帶銅絞線的繼電器,負載引腳不能焊錫,引腳針剛性固定,不能隨意扭動。

                     

                    1. All the relays are shipped in the "operate" position because it is possible that during transit or final assembly the relay could change its state to the "release" position. please reset the relay into "operate" state when put in circuit according to need.

                    2. In order to maintain "operate" or "release" state of the relay, the coil voltage should reach the rated voltage. The pulse width should be 60ms or longer to ensure a proper change of state. Do not enegize both Pin1 and Pin2 at the same time on the coil for longer than 1 min (damage to the coil).

                    3. Relays are classified according to the polarity, if client need different form from information, please contact us.

                    4. The relay into the factory for destructive inspection should be protected from damage and strict distinction between the normal products.

                    5. Now with braided line relay, the load pin can not solder, not arbitrarily wrenched, two pins and righid fixation.

                     


                    觸點特性/Contact specification
                    參數 (Parameter) (Date)
                    觸點材料(Contact material)AgSnO2
                    接觸電阻(Contact resistance)0.6mΩ MAX.(12VDC 1A)
                    額定負載((Contact currentt)120A/250VAC
                    最大斷開電壓
                    (Max disconnection voltage)
                    440VAC/110VDC
                    最大斷開功率
                    (Max disconnection power)
                    30000VA
                    電氣壽命(Electrical life)5000 cycles
                    機械壽命(Mechanical life)100000 cycles
                    基本特性/Basic parameter
                    參數 (Parameter) (Date)
                    線圈脈沖設置寬(Coil pulse width)50ms Min.
                    動作時間(Operation time)30ms Max.
                    復歸時間(Comeback time)30ms Max.
                    介質耐壓
                    (Dielectric strength)
                    觸點與線圈間
                    (Between contact & coil)
                    4000VAC 

                    (50/60Hz) for 1 min

                    斷開觸點間
                    (Between contacts)
                    2000VAC 

                    (50/60Hz) for 1 min

                    絕緣電阻(Insulation resistance)Min.1000MΩ(at 500VDC)
                    環境溫度(Ambient temp)-40~+70℃
                    重量(Weight)280g


                    返回上一頁
                    產品中心
                    新聞資訊
                    服務支持
                    資質文件
                    睿奕介紹
                    廣西睿奕科技開發有限公司 GUANGXI RAMWAY TECHNOLOGY CO LTD latching relay magnetic relay ? All Rights Reserved.    
                    99久久精品国产一区二区三区_日本强伦姧护士在线播放老师_成人影院yy111111在线_污草莓丝瓜榴莲深夜释放自己

                        <ins id="pvjdx"><th id="pvjdx"></th></ins>

                          
                          

                                <address id="pvjdx"><nobr id="pvjdx"><meter id="pvjdx"></meter></nobr></address>

                                <form id="pvjdx"></form>

                                <address id="pvjdx"><nobr id="pvjdx"><nobr id="pvjdx"></nobr></nobr></address><form id="pvjdx"><form id="pvjdx"><nobr id="pvjdx"></nobr></form></form>

                                    <form id="pvjdx"><nobr id="pvjdx"></nobr></form>

                                      欧洲vodafonewifi巨大野外版| 农民工嫖妓50岁老熟女| 韩国三级日本三级人与波| 斗破苍穹年番在线观看| 日韩人妻无码一区二区三区综合部| 娇妻被黑人杂交下呻吟| 丰满的已婚女人hd中字| 免费av| 另类zoofilia杂交videos新|